Specially made for the excellent bonding in handicraft industry and bonds laminate/ acrylic/wood/veneer sheet to wood/ply/flush door/MDF/HDF. It is used in lamination application in Modular Furniture and Wood Working industries. It can be used as fast setting adhesive.

• The surfaces should be free from dust, oil and grease. They should be dry and properly leveled. For best results, roughen the surfaces to be bonded.
• Ensure adhesive container is stirred well before use.
• Mix the WINDFIX BWR adhesive with WINDFIX HARDNER in the ratio of 100:4 (4 to 5) by weight and mix it thoroughly.
• WINDFIX BWR adhesive should be applied as a thin, even coating to one surface only.
• FOR PLY TO LAMINATE: Before allowing adhesive to dry, bring both the surfaces in contact, align properly and start pressing from one side by using wet squeezed cloth to avoid bubbles and ensure uniform contact.
• FOR WOOD TO WOOD: Before allowing adhesive to dry, bring both surfaces in contact and align properly. To get best results keep them pressed for 24 hours. 
• Excess adhesive that oozes out from edges should be wiped off with a wet squeezed cloth. 
• Pressure can be applied by using Clamps, Weight, Cold Press, Hot Press, Roller Press etc. 
• If required, pressure can be released after 3 to 4 hours and then bonded assembly can be processed further.
• The surfaces should be free from dust, oil and grease. They should be dry and properly leveled. For best results, roughen the surfaces to be bonded.
• Ensure adhesive container is stirred well before use.
• Mix the WINDFIX BWR adhesive with WINDFIX HARDNER in the ratio of 100:4 (4 to 5) by weight and mix it thoroughly.
• WINDFIX BWR adhesive should be applied as a thin, even coating to one surface only.
• FOR PLY TO LAMINATE: Before allowing adhesive to dry, bring both the surfaces in contact, align properly and start pressing from one side by using wet squeezed cloth to avoid bubbles and ensure uniform contact.
• FOR WOOD TO WOOD: Before allowing adhesive to dry, bring both surfaces in contact and align properly. To get best results keep them pressed for 24 hours. 
• Excess adhesive that oozes out from edges should be wiped off with a wet squeezed cloth. 
• Pressure can be applied by using Clamps, Weight, Cold Press, Hot Press, Roller Press etc. 
• If required, pressure can be released after 3 to 4 hours and then bonded assembly can be processed further.

• Excellent Boiling water resistance and Heat resistance properties. It also meets the requirement of Stress Group D4.
• Ready to use and high bonding strength.
• Higher coverage compared to solvent based adhesive of 86-90 sq. feet/kg.
• Easy to apply by brush, spatula or glue roller.
• Solvent free, non-hazardous, non flammable, free formaldehyde.
• No stains after drying, Easy sand ability, Easy to clean when wet. 

WINDFIX BWR must be stored and maintained in proper cool and dry storage condition. Iron or galvanized-iron equipment and containers are not recommended because the adhesive is slightly acidic.WINDFIX BWR must be stored and maintained in proper cool and dry storage condition. Iron or galvanized-iron equipment and containers are not recommended because the adhesive is slightly acidic.

If stored in the original, unopened containers at cool (below 30°C) and dry place WINDFIX BWR has a shelf life of 9 months from the date of manufacture. 

500gm, 1kg, 2kg, 5kg, 10kg, 20kg, 50kg